Extron RGB-HDMI 300 A Video Scaler driver for Windows 7 - Extron RGB-HDMI 300 A Video Scaler driver from Ex

Extron RGB-HDMI 300 A Video Scaler 1.16

Extron RGB-HDMI 300 A Video Scaler driver from Extron for OS Independent

Extron RGB-HDMI 300 A Video Scaler driver from Extron for OS Independent

Publisher review for Extron RGB-HDMI 300 A Video Scaler 1.16:

Before install Extron RGB-HDMI 300 A Video Scaler 1.16you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Extron RGB-HDMI 300 A Video Scaler . We recommend to always use most recent version of a driver.

This package provides the necessary installation files of Extron RGB-HDMI 300 Video Scaler Firmware version 1.16.Fixes:- Improved factory calibration procedure to facilitate accurate RGB / YUV uniformity - Implemented a firmware update to provide for more accurate and uniform factory calibration. This update in no way affects customer facing unit operation.
Installation steps:1. Download the firmware file.
2. Power on the scaler and a computer with internet access.
3. Connect the computer to the video scaler through either the front panel Config port or the rear panel RS-232 captive screw connectors.
4. Open the Extron Firmware Loader by double-clicking on the desktop icon or selecting it from the start menu. The Connection dialog box opens.
5. From the drop-down menus, select the device name, the connection method ( RS-232 ), the COM port, and the baud rate.
6. Click on the connect button. When the connection is made, the name of the device appears, with a green check mark, in the Connected Device box.
7. Click the Browse button and navigate to the folder where the firmware file was saved.
8. Click Add button. The Add Device screen closes to reveal the main Firmware Loader window.
9. Click the Begin button. The firmware transfer takes approximately 3 minutes. The progress of the transfer is shown by a green bar in the Total Progress panel.
NOTE: During the firmware upload, the front panel LED and video output are disabled.
10. When the transfer is complete, the Progress column in the Devices pane reads 100% and the Status column reads Complete.

Operating system:
OS Independent