HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub driver for Windows 7 - HP EliteBook Folio 1020 G1 Synaptics Docking Stati

HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub 2.27.000 Rev.A

HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub driver from HP for

HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub driver from HP for Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 8.1, Windows 8.1 64 bit

Publisher review for HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub 2.27.000 Rev.A:

Before install HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub 2.27.000 Rev.Ayou should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of HP EliteBook Folio 1020 G1 Synaptics Docking Station Display Port Hub . We recommend to always use most recent version of a driver.

HP 2013 Ultraslim Docking Station DisplayPort Hub Firmware Update provides the EEPROM firmware required to enable the DisplayPort hub on the HP Ultraslim Docking Station. This package is provided for supported notebook models running a supported operating system. Fixes:
- Fixed the no display issue after back from turn off display state with AMD source
- Fixed the compatible issue with Philips 241P with AMD source

Installation steps:
1. Download the file to a folder on your hard drive .
2. Dock the notebook unit to the HP Ultraslim Docking Station.
3. Connect a monitor to the docking station DP port using the native DisplayPort or a DP-to-VGA adapter. Then make sure the monitor is enabled from the Windows Display Manager.
4. After the DP monitor is enabled and powered on, double click the file to run the executable. The progress bars will indicate that the update process has started.
WARNING: Do not disconnect the notebook from the dock or remove the DP monitor during this process. Performing either of these actions may cause the DP hub to become unusable.
5. Verify that the update was successfully completed by observing the status of the tool. The status should display the message, "Action complete. Downloading to storage...Success."
6. After the update is complete, undock and re-dock the notebook to enable the new firmware version.
Important notes:- Before installation, save all your work and close all the running programs, as the installation may interfere with other apps;
- If the setup requests Administrative rights, make sure to run the setup as Administrator;
- Pay attention to all installation instructions to make sure the driver is installed correctly; 

Operating system:
Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 8.1, Windows 8.1 64 bit