Intel S2600KP Server Board UEFI driver for Windows 7 - Intel S2600KP Server Board UEFI driver from Intel

Intel S2600KP Server Board UEFI 1.01.0016

Intel S2600KP Server Board UEFI driver from Intel for OS Independent

Intel S2600KP Server Board UEFI driver from Intel for OS Independent

Publisher review for Intel S2600KP Server Board UEFI 1.01.0016:

Before install Intel S2600KP Server Board UEFI 1.01.0016you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Intel S2600KP Server Board UEFI . We recommend to always use most recent version of a driver.

Versions: - System BIOS - R01.01.0016
- ME Firmware - 03.01.03.021
- BMC Firmware - 01.43.9685
- FRUSDR - 1.14
Update Procedure: - Unzip the contents of the update package and copy all files to the root directory on a USB flash drive
- Insert the USB flash drive to any available USB port on the server system to be updated
- Power on the server
- The system will automatically access the uEFI shell and begin the update process.

Or

- If the files were copied to a folder other than the root, Boot the Server to the uEFI shell. This can be accessed via the <F2> BIOS setup utility during POST or via the <F6> Boot Menu accessed during POST.
- Run the command "map -r" in the uEFI shell to mount the USB flash drive
- Run the command "fs0:" to change folders to the USB flash drive. The USB flash drive may also mount to fs1: depending on other installed devices. The number of "fs#" is dependent on the result of command "map -r"
- Change folders to the folder holding the update package files and manually start the "Startup.nsh" script file to start loading all updates
- Reboot the system after the update process has successfully completed
Verifying Updates: - During POST, hit the <F2> Key when prompted to access the BIOS Setup Utility
- From the BIOS Setup Utility main menu, Hit the <F9> key to load BIOS Defaults
- At the MAIN menu verify the BIOS revision is correct
- Move cursor to the SERVER MANAGEMENT Menu
- Move cursor down to the SYSTEM INFORMATION Option and hit Enter
- Verify the BMC Firmware revision is correct
- Verify the SDR revision is correct
- Verify the ME Firmware revision is correct
- Configure desired BIOS Option settings
- Hit the F10 Key to save changes and Exit
- The System Software Update is Complete.

Operating system:
OS Independent