Panasonic DMC-GH4 Camera driver for Windows 7 - Panasonic DMC-GH4 Camera driver from Panasonic fo

Panasonic DMC-GH4 Camera 2.5

Panasonic DMC-GH4 Camera driver from Panasonic for OS Independent

Panasonic DMC-GH4 Camera driver from Panasonic for OS Independent

Publisher review for Panasonic DMC-GH4 Camera 2.5:

Before install Panasonic DMC-GH4 Camera 2.5you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Panasonic DMC-GH4 Camera . We recommend to always use most recent version of a driver.

Changes:- [Post Focus] is added. This function enables users to set the focus point after shooting and save as a separate photo.
- Three 4K PHOTO modes: [4K Burst] [4K Burst Start/Stop] [4K Pre-Burst] are added to help users capture the unmissable moments and users can choose a best shot with easy, intuitive touch-control operation after shooting.
- External flash can be used in burst shooting. DMW-FL580L, DMW-FL360L only.
- Free 100GB storage on Google Drive is offered to LUMIX GH4 users (2 years). It can be used for photo/video data saving and accessed through multiple devices such as camera, PC, smartphone/tablet. Users need to register to LUMIX CLUB to get the ID in advance and activate the account service by 30 September 2016.
- [AF-ON] function can be uesd during video recording.
- The accuracy of digital red eye correction in the RAW development is improved.
- The time lag of stop signal transmission through HDMI is adjusted to make the length of the recorded contents same either on the SD Memory Card or on the external recorder via HDMI.
Update Procedure:- Charge the battery fully.
- Make sure to turn off the power switch.
- Insert the fully charged battery to the body.
- Save and unzip the downloadable package.
- Transfer the content onto a formatted SD memory card.
- Insert the Card into the camera body and make sure that an HDMI cable is not connected between DMW-YAGH interface unit and DMC-GH4 camera body.
- Turn on the power switch.
- Press the Play button to enter the Play mode.
- After the message of "PLEASE WAIT ..." is displayed, a display will continuously be shown on the LCD.
- If newer version or same version of firmware has already been installed, the initial setup screen will not be displayed. And the lens will display that "NO VALID PICTURE TO PLAY". Please turn off your camera and use the camera as is.
- Press [(Left Cursor button)] to select the [Yes]. The update process will start.
- The camera body will start the update process.
- The firmware update will take about 5 minutes.
- Please do not attempt the following operations before completion.
- The green bar increases the level by the process.
- Once the firmware update process is completed, the camera dody will turn off the power and turn on again then it will be initial mode automatically.
- Turn off the power switch.
- Remove the SD memory card.
Important Notes:- Do not turn the power off and on
- Do not press any buttons
- Do not open the SD memory card compartment
- Do not remove the SD memory card
- Do not remove the lens.

Operating system:
OS Independent