Sony Alpha DSLR-A100H Camera driver for Windows 7 - Sony Alpha DSLR-A100H Camera driver from Sony for

Sony Alpha DSLR-A100H Camera 1.04

Sony Alpha DSLR-A100H Camera driver from Sony for Windows 7, Windows 7 64 bit, Windows 8,

Sony Alpha DSLR-A100H Camera driver from Sony for Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 8.1, Windows 8.1 64 bit, Windows 10, Windows 10 64 bit

Publisher review for Sony Alpha DSLR-A100H Camera 1.04:

Before install Sony Alpha DSLR-A100H Camera 1.04you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Sony Alpha DSLR-A100H Camera . We recommend to always use most recent version of a driver.

This utility updates the camera firmware to version 1.04 and provides the following benefits: Improvements over firmware version 1.02:- Adds support for the camera to display focal length information about an attached Zoom Lens DT 55-200mm F4-5.6.
Additional improvements over original firmware:- Addresses the symptom where, in very rare cases, RAW format files may not be opened by the supplied image control software, Picture Motion Browser.
- Improves image gradation when the shutter speed is 1 second or longer.
- Improves printed picture quality when the image is printed by Epson printer under PRINT Image Matching.
Update the FirmwareWARNING!!: When performing the firmware update, use fully charged rechargeable battery pack NP-FM55H or the AC adapter AC-VQ900AM AC adapter/charger (sold separately). Do not remove the battery or AC adapter during the firmware updating, otherwise the camera may be permanently damaged.
- If it is not already there, insert the formatted recording media (Memory Stick Duo / CF card / Microdrive) into the camera and then slide the POWER switch to the On position.
- Press the (playback) button.
- Use the controller () to highlight "Yes", then press the Center button of controller. The Updating procedure will start.
Note: "No" will cancel the operation.
- When the "Updating-completed" message appears, the updating procedure is complete. Turn the camera off, then remove the recording media.

Operating system:
Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 8.1, Windows 8.1 64 bit, Windows 10, Windows 10 64 bit