VIA Labs VL810 / VL811 Controller Utility 0.41 / driver for Windows 7 - VIA Labs drivers for Windows 7

VIA Labs VL810 / VL811 Controller Utility 0.41 / 0.89 Beta

Download Firmware drivers from VIA Labs for Windows 7

VIA Labs VL810 / VL811 Controller Utility 0.41 / driver from VIA Labs for Windows XP / Windows Vista / Windows XP X64 / Windows Vista64 / Windows 7 / Windows 7 x64

Publisher review for VIA Labs VL810 / VL811 Controller Utility 0.41 / 0.89 Beta:

Before install VIA Labs VL810 / VL811 Controller Utility 0.41 / 0.89 Betayou should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of VIA Labs VL810 / VL811 Controller Utility 0.41 / . We recommend to always use most recent version of a driver.

VIA Labs USB 3.0 Hub Controller Utility upgrades the firmware used by the VL810 Superspeed USB Hub Controller.

Firmware Release Notes:

Release number: 0008_9 BETA

- USB 3.0:
1. Code consolidation

- USB 2.0:
1. Fixed an issue that occurred when VL810 was connected downstream to particular Charger ICs during S3/S4, where VL810 would initiate remote-wake after Charger IC toggled Vbus.

NOTE:
This is a BETA firmware release for testing purposes only. BETA FW have not been fully validated so test-report data is unavailable. If you experience issues with this BETA FW, please contact your VIA Labs representative.



Operating system:
Windows XP / Windows Vista / Windows XP X64 / Windows Vista64 / Windows 7 / Windows 7 x64