Bushnell Equinox Z 260150 Monocular driver for Windows 7 - Bushnell Equinox Z 260150 Monocular driver from

Bushnell Equinox Z 260150 Monocular for OS Independent

Bushnell Equinox Z 260150 Monocular driver from for OS Independent

Bushnell Equinox Z 260150 Monocular driver from for OS Independent

Publisher review for Bushnell Equinox Z 260150 Monocular for OS Independent:

Before install Bushnell Equinox Z 260150 Monocular for OS Independentyou should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Bushnell Equinox Z 260150 Monocular . We recommend to always use most recent version of a driver.

This package provides the necessary installation files of Bushnell Equinox Z 260150 Monocular Firmware.New features:- Video Out: This will disable the 10 minute automatic shut off when the video out cable is plugged in and video out is engaged.
- LCD Brightness: The LCD will now have a lower brightness setting - lowering the brightness by 50% If the user so chooses. This requires a specific button sequence to engage once the software upgrade is in place.
How do you know if you need the update?- If you purchased a Bushnell Equinox Z 6x 50mm (260150) with a code of “D011213” (The white number on the under side of the rubber SD card slot cover).
Installation steps:1. Download and unzip the upgrade file: Update for Equinox Z 6x 50mm 260150).
2. Using a Windows based computer, place the unzipped files onto a freshly formatted SD Card and place the SD card into your Equinox Z night visioin monocular.
3. Install the fresh batteries and power on the monocular.
4. Press the following button in sequence: Zoom out + FPS Button + FPS Button + Zoom in + FPS button.
5. The FW upgrade menu will appear. Press Zoom out to start the upgrade. The word “ISP” will be displayed on the screen during the upgrade. The upgrade should take less than 5 minutes to install.
6. The monocular will shut off once the upgrade is complete.
7. Reboot the monocular.
New Brightness Feature: - Once the upgrade is complete and you have rebooted the monocular, the brightness button will still power through the normal FPS adjustment rate. To get to the NEW settings, press and hold the brightness button for two seconds. The display will prompt you with a “Backlight Low” which you can use to cycle through the different series of brightness’s in low mode.
- To get back to the high settings, press and hold the brightness button again, or you can permanently leave them on low.

Operating system:
OS Independent