Sony Alpha DSLR-A900 Camera driver for Windows 7 - Sony Alpha DSLR-A900 Camera driver from Sony for

Sony Alpha DSLR-A900 Camera 2.00

Sony Alpha DSLR-A900 Camera driver from Sony for Windows XP, Windows Vista, Windows XP 64

Sony Alpha DSLR-A900 Camera driver from Sony for Windows XP, Windows Vista, Windows XP 64 bit, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit

Publisher review for Sony Alpha DSLR-A900 Camera 2.00:

Before install Sony Alpha DSLR-A900 Camera 2.00you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Sony Alpha DSLR-A900 Camera . We recommend to always use most recent version of a driver.

This utility updates the camera firmware to version 2.00 and provides the following benefits:- Adds the ability to release the shutter even when no lens is mounted on the camera.
- Expands the Exposure Compensation range to ± 5 EV.
Note: The range before the update is ± 3 EV.
- Adds a new Bracket Shooting setting to allow a deviation of 3.0 EV.
Note: The maximum deviation setting before the update is 2.0 EV.
- Improves the auto focus (AF) speed. This is especially noticeable when using a telescopic lens.
Note: The improvement varies depending on the lens used and shooting conditions.
Update the FirmwareWARNING!!: When performing the firmware update, use fully charged rechargeable battery pack NP-FM500H or the AC-PW10AM AC Adaptor (AC adaptor sold separately). Do not remove the battery or AC adapter during the firmware updating, otherwise the camera may be permanently damaged.
- Slide the POWER switch to the ON position and set the "Memory card" to the type you are using for the update (Memory Stick Duo / CF card / Microdrive) in Setup Menu 2 , then slide the POWER switch to the OFF position.
- If it is not already there, insert the formatted recording media (Memory Stick Duo / CF card / Microdrive) into the camera
- Press and hold the MENU button. While holding the MENU button, slide the POWER switch to the ON position. Continue to press the MENU button until the confirmation window appears.
- The confirmation window appears.
- Use the Multi-selector to highlight "OK", then press the Center button of the Multi-selector. The Updating procedure will start.
- When the "Update is completed" message appears, the updating procedure is complete.
Note: The camera automatically restarts after about 5 seconds.
- Power off the camera, then remove the recording media.

Operating system:
Windows XP, Windows Vista, Windows XP 64 bit, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit