Sony HDR-AS200VT Action Camera driver for Windows 7 - Sony HDR-AS200VT Action Camera driver from Sony f

Sony HDR-AS200VT Action Camera 2.00

Sony HDR-AS200VT Action Camera driver from Sony for Windows Vista, Windows Vista 64 bit,

Sony HDR-AS200VT Action Camera driver from Sony for Windows Vista, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 8.1, Windows 8.1 64 bit

Publisher review for Sony HDR-AS200VT Action Camera 2.00:

Before install Sony HDR-AS200VT Action Camera 2.00you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Sony HDR-AS200VT Action Camera . We recommend to always use most recent version of a driver.

Fixes:- "Loop recording" mode has been added to shooting mode setting 
- The following features have been added to camera setting 
- Image quality setting has been added 
- Movie format setting has been added 
- Date and time/area/daylight saving time (summer time) setting has been changed
- Time zone of some areas has been changed 
Firmware update steps:1. Close all currently running programs on your computer.
2. Double-click the file you downloaded to start up the Firmware Updater.
3. Remove the memory card from the camera beforehand. Connect the camera to the computer with the supplied USB cable. USB Mode appears on the LCD monitor of the camera.
4. If the computer cannot find the camera, the message " Could not find the camera for this update." appears on the computer display. Try the following if this happens:
- Disconnect the USB cable and connect it again.
- If the computer has multiple USB terminals, try with the other terminals. Your computer may have some USB terminals on the backside.
- Sometimes when the camera is connected to the computer with the USB cable, the message to encourage rebooting the computer may appear on the computer display. In this case, remove the battery pack from the camera, reboot the computer and try again.
5. Confirm the "Safely Remove Hardware" icon is displayed on the task tray at the lower right corner of the computer screen.
6. After confirming the above, click Next on the Firmware Updater window. From now on, never turn off the camera until the firmware update is completed.
7. The current version and the version after the update appear on the lower left part of the screen. If the current version and the version after the update are the same, update is not required (In that case, stop the USB connection and click Finish. Turn off the camera, remove the battery pack, reinsert the battery and turn on the camera).
8. Click the "Safely Remove Hardware" icon on the task tray at the lower right corner of the computer screen to stop the USB connection. Please keep the USB cable connected even after stopping the USB connection on the computer.
9. Press [REC/ENTER] to execute the reset of the camera.
10. Click Next on the Firmware Updater window.
11. After resetting, reconnection of the camera is verified.
12.Click Run to start the update. The progress bar appears while updating (approximately 10 minutes). Never turn off the camera nor disconnect the USB cable while updating.
13. When the update is completed, click Finish and disconnect the USB cable.
14.Turn off the camera, remove the battery pack, reinsert the battery and turn on the camera again.
Important notes:- When performing the firmware update, please use a fully charged rechargeable battery pack..
- Do not remove the battery during the update; otherwise, the camera may become inoperable due to the sudden power shutdown.
- Remove the memory card from the camera beforehand.

Operating system:
Windows Vista, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 8.1, Windows 8.1 64 bit